Equipment
My current equipment includes the following
Mount
Optical Assembly
- Astro-Tech 12″ RC f/8
- 3″ Feather-Touch Focuser
- HSM 30 Handy Stepper Motor
- Focuser Boss II Electronic Focusing Control
- Pyxis 3″ Camera Rotator
Camera
- SBIG STT-8300M (imaging camera)
- FW8G-STT (self-guiding filter wheel)
- AO-8T (adaptive optics)
- Baader LRGB 36mm filters
- Astrodon Narrowband 36mm filters 5nm OIII, Halpha and SII
Software
Power Supply
- Renogy Deep Cycle AGM Battery 12 Volt 200Ah
Other Accessories
- 2″ 650nm Howie Glatter (with concentric circle projection attachement)
- GoldFocus Focusing Mask
- Telrad
- Few Eyepieces
- Cheap Binoviewer
- x2 Televue Barlow
- Custom made 14″ Flat Panel
Lonely Photons 
Hello
My name is Juan José, from Spain
I have a Paramount MX with the same problem as you show in your video https://www.youtube.com/watch?v=SYpZASFJylU
Did you solve it? Is related with some kind of damage in the homing sensor cable?
If so, is there any video showing how to change it?
Thank you so much
Hi Juan. Sorry, I don’t often log in and did not see your comment until now. I hope you fixed your issue by now. The homing issue was due to a disconnected cable. While pulling cables through the mount, I accidentally disconnected one of the sensors. After reconnecting it, everything went back to normal. Good luck and don’t hesitate to contact the Software Bisque support team.